Serendipity Forums

Hi,
i am a total newbie in the blog-field

I managed it however to install it properly... At least I thought so.

Now I have this problem when I try to enter the admin area to make any changes.
Right after installation I was able to do so and just installed spartacus. Now the admin area looks like this...


Hope you can tell what to do...

Thanks

Hi!

Did it look like this immediately after spartacus installation? Or did you change any other things?

Usually it should only look like this if you changed the user configuration and set "Allow to create entries" to "no"...

Best regards,
Garvin

Hey,

honestly, I don't know if I might accidentally switched that to "no"...

Because I did not make any more changes than spartacus, I decided to make a complete new installation.

I will test it now and watch the "Allow to create entries"

Thank you

Chris